Quantum dot charge transport can behave in ways that challenge familiar rules of semiconductor physics. In many hopping systems, lower temperature reduces the thermal energy available to move charge between localized sites, slowing transport. Yet measurements on well-ordered lead sulfide (PbS) quantum dot solids found that carrier mobility could increase as temperature fell. The key is that temperature changes not only carrier energetics, but also the spacing between neighboring quantum dots.
This distinction matters when interpreting temperature-dependent mobility. An increase in mobility during cooling is often associated with band-like transport, in which carriers move through delocalized states and encounter less phonon scattering at lower temperatures. The PbS results show that this trend alone does not establish band-like behavior: structural changes in a hopping material can produce a similar temperature response.
How quantum dot charge transport works
In a quantum dot (QD) solid, charge carriers move between individual nanocrystals. The process is commonly described as hopping: a carrier occupies a localized state on one dot, then tunnels to a neighboring dot. The rate depends on both the energetic relationship between sites and the distance separating them.
The energetic contribution is influenced by site-to-site energy differences and thermal fluctuations. For an uphill transition to a higher-energy site, thermal activation is important; lowering temperature generally makes that transition less likely. The distance contribution arises because the electronic wavefunctions on adjacent dots overlap less as the gap between them increases. Tunneling rates therefore depend strongly on inter-dot separation.
These two effects can compete. Cooling can suppress thermally assisted hopping while simultaneously bringing neighboring dots closer together. If the reduction in distance is large enough, the resulting increase in tunneling can outweigh the loss of thermal activation.
Evidence from PbS quantum dot solids
The study examined ethanethiol-treated PbS QD solids across a temperature range, using broadband infrared transient absorption spectroscopy to track carrier relaxation. After photoexcitation, the transient absorption bleach shifted to lower energy over time. This redshift reflects carriers moving among dots with differing site energies and relaxing toward lower-energy states—a characteristic of hopping among localized states.
The researchers modeled the measurements with a site-to-site hopping framework that accounts for energetic disorder and temperature-dependent rates. The model indicated that the average hopping rate increased as temperature decreased in the more energetically homogeneous samples. It also showed that energetic disorder can change the outcome: in the smallest-dot sample, with greater inhomogeneous broadening, the hopping rate and mobility eventually declined at lower temperatures because carriers had insufficient thermal energy to navigate the distribution of site energies.
The model attributed the unexpected trend to contraction of the quantum dot superlattice. It predicted a reduction in nearest-neighbor edge-to-edge spacing of approximately 0.9–1.7 angstroms between 300 K and 150 K. Although small in absolute terms, this change can substantially affect tunneling because the distance dependence is exponential.
Structural measurements support the mechanism
Grazing-incidence small-angle X-ray scattering (GISAXS) provided independent evidence that cooling can alter quantum dot lattice structure. In a separate ordered superlattice made with oleic-acid-capped PbS dots, the scattering patterns showed a change from a face-centered cubic structure at 298 K to a body-centered tetragonal structure at 133 K. The distortion reduced the nearest-neighbor spacing overall.
The GISAXS sample used longer oleic acid ligands than the ethanethiol-treated solids measured by transient absorption, so its measured structural change should not be treated as a direct measurement of the exact contraction in the transport samples. Instead, the structural data support the broader mechanism: ligand shells and superlattice geometry can respond to temperature, changing the separation between neighboring nanocrystals. The transport model’s smaller predicted contraction for ethanethiol-treated dots is consistent with the difference in ligand length.
Why rising mobility does not prove band-like transport
Carrier mobility was calculated from simulated diffusion following thermalization. For the more homogeneous QD solids, the results showed mobility increasing as temperature decreased, because the effect of shorter inter-dot spacing outweighed the thermally activated contribution to hopping.
However, the transient redshift and relaxation into lower-energy sites remained evidence of hopping between localized states. The study did not observe spectral signatures of band-like transport over the temperature range investigated. Its central interpretive point is therefore important: a negative temperature dependence of mobility—mobility rising during cooling—is supporting evidence for band-like transport in some contexts, but it is not conclusive on its own.
Material structure and measurement method also matter. The work concerns intrinsic carrier mobility inferred from transient optical measurements and modeling. Device-level measurements, such as field-effect mobility, can include additional influences, including trapping, detrapping, and interfaces. Those effects should not be conflated with the microscopic transport behavior examined here.
Practical implications for materials analysis
For engineers and technical teams evaluating temperature-dependent transport in nanostructured semiconductors, the results argue for considering structure alongside electrical or optical response. A mobility trend can reflect changes in the transport mechanism, but it can also arise from temperature-dependent geometry that changes the tunneling distance.
- Interpret mobility trends cautiously: increasing mobility on cooling does not, by itself, distinguish hopping from band-like transport.
- Account for inter-particle spacing: small changes in nearest-neighbor distance can have a large effect on tunneling rates.
- Consider energetic disorder: the balance between structural contraction and thermal activation depends on the spread of site energies.
- Pair transport measurements with structural characterization: methods such as GISAXS can help identify lattice changes that may affect charge motion.
The findings connect microscopic transport behavior to the organization of nanocrystals and their ligand shells. In PbS quantum dot solids, cooling can strengthen hopping by contracting the superlattice, even as thermal activation becomes less favorable. The practical lesson is to interpret temperature-dependent mobility in the context of both energetic disorder and structural change—not as a standalone indicator of band-like transport.