A Cr spacer in Fe/Gd multilayers can reshape both the interface coupling and the magnetic behavior of the layers themselves. Comparative measurements of Fe/Gd and Fe/Cr/Gd superlattices show that inserting a chromium layer about 4 Å thick substantially weakens antiferromagnetic coupling between iron and gadolinium. It also coincides with structural changes in Gd and differences in magnetization, resonance and domain behavior. These results matter when designing or interpreting magnetic heterostructures: a spacer cannot be treated as a purely passive separator.
Why Fe/Gd multilayers have complex magnetic states
Iron and gadolinium are both ferromagnetic materials, but their moments couple antiferromagnetically at Fe–Gd interfaces. In other words, the interfacial Fe and Gd magnetizations favor opposite directions. The resulting state depends on the balance among this exchange interaction, interactions within Gd, temperature and applied magnetic field.
Gd magnetization can vary through the thickness of a layer rather than switching as a single uniform block. This makes Fe/Gd systems capable of different magnetic arrangements, including Fe-aligned, Gd-aligned and twisted states. A twisted state develops when the magnetization direction changes across a Gd layer. Measurements across a broad temperature and field range are therefore useful for distinguishing changes in coupling from changes in the internal magnetic profile.
What the Cr spacer changes
The comparison examined repeated Fe/Gd layers and a structure with Cr spacers on both sides of each Gd layer. The nominal Fe and Gd thicknesses were approximately 35 Å and 50 Å, respectively, with a Cr spacer about 4 Å thick. X-ray reflectivity confirmed a well-defined layered structure, with interfacial roughness of roughly one to two atomic monolayers.
Diffraction measurements identified a structural difference associated with the spacer. The Fe/Gd sample showed a broad reflection attributed to hexagonal-close-packed (hcp) Gd. In the Fe/Cr/Gd sample, the diffraction pattern also included a reflection associated with face-centered-cubic (fcc) Gd. The coexistence of these phases indicates that inserting Cr changes the structure of the Gd layers, not just the chemical separation between Fe and Gd.
Magnetization measurements and mean-field modeling showed that the Cr spacer reduces the antiferromagnetic interlayer exchange by more than an order of magnitude. The coupling remains antiferromagnetic, but is much weaker. The analysis also indicated a lower effective exchange stiffness within Gd for the Fe/Cr/Gd structure. The researchers proposed that the observed reduction in interface coupling may be influenced by pinholes: because the spacer thickness is comparable to the interface roughness, some regions may not be fully separated by Cr. The fitted coupling should therefore be understood as an effective, averaged parameter.
Magnetization is not uniform across Gd
Polarized neutron reflectometry (PNR) and resonant X-ray magnetic reflectometry (RXMR) were used together to examine the depth-dependent magnetization. These techniques distinguish magnetic contributions through a multilayer rather than reporting only a total moment. At 15 K and 500 Oe, the measurements showed that Gd magnetization was nonuniform in both samples.
In Fe/Gd, the fitted Gd moment reached about 7 μB per atom near the interfaces and about 5 μB per atom in the layer center. In Fe/Cr/Gd, the moment was about 7 μB per atom at the Gd/Cr interfaces and about 4 μB per atom in the center. The enhanced interfacial moment extended over a region roughly 10 Å thick. Fe-layer moments measured by these techniques were close to the bulk value, while the Gd profile varied substantially with position.
This interfacial enhancement is a proximity effect associated with the neighboring magnetic layer. It also helps explain why total magnetization can be difficult to interpret: oppositely aligned Fe and Gd moments partially compensate one another. The Cr spacer appears to suppress this effect, contributing to a slight increase in the net Fe-layer magnetization inferred from the broader analysis.
Temperature, resonance and magnetic history
Static magnetometry, magneto-optical Kerr effect (MOKE) measurements and ferromagnetic resonance (FMR) provided complementary views of magnetic behavior. The magnetization curves showed nonlinear approach to saturation at lower temperatures, consistent with twisted magnetization in Gd. A mean-field model reproduced the main trends when it accounted for temperature dependence of the effective field parameter in Gd.
FMR measurements revealed two resonance branches. The low-temperature, high-field peak was associated with an in-phase precession mode of Fe and Gd. A second, inhomogeneous exchange mode involved opposing precession in the central Gd region and the Fe layers. Because the spacer weakens interlayer exchange, the Fe/Cr/Gd sample had a smaller spectral gap for this mode, which appeared at a lower temperature in fixed-frequency measurements.
MOKE measurements also showed a difference in low-field behavior. The Fe/Cr/Gd sample exhibited stronger hysteresis at low temperatures, indicating a greater role for magnetic domains and magnetic history. Its measured compensation temperature—where the remanent MOKE signal passed through zero—was about 60 K, compared with about 90 K for Fe/Gd. A compensation point reflects balance in the measured magnetic response; it should not be mistaken for the disappearance of magnetization in each individual layer.
Implications for multilayer design and analysis
The practical lesson is that inserting an ultrathin nonmagnetic layer can affect several coupled features at once. In this system, the Cr spacer:
- Weakens antiferromagnetic exchange between Fe and Gd without changing its sign.
- Coincides with the appearance of fcc as well as hcp Gd diffraction signatures.
- Changes the effective Gd exchange stiffness and the magnetic response across temperature.
- Alters the observed compensation behavior and increases the apparent role of domains at low fields.
For engineers and technical teams working with magnetic thin films, this is a reminder to evaluate spacer layers alongside interface roughness, crystallographic structure and depth-dependent magnetization. A single bulk or surface measurement may not capture the internal magnetic configuration. Combining structural characterization with magnetometry, MOKE, FMR and depth-sensitive reflectometry provides a more complete basis for interpreting multilayer behavior.
Conclusion
A thin Cr spacer in Fe/Gd multilayers does more than reduce direct Fe–Gd exchange. The comparative study links the spacer to changes in Gd crystallinity, magnetic stiffness, interfacial magnetization and domain-sensitive behavior, while showing that the underlying coupling remains antiferromagnetic. For multilayer design, spacer thickness and interface quality should be considered together with the magnetic state of each layer. Understanding those interactions is essential to predicting how a structure will respond to temperature and applied field.