Access Official Technical PDF

Share Summary:LinkedInEmail

Iowa’s 2017 greenhouse gas emissions inventory offers a detailed view of how energy use, industrial production, agriculture, transportation, and waste contributed to statewide emissions. For plant managers, operations leaders, and industrial decision-makers, the results are useful not only as an environmental snapshot but also as an example of how facility data, sector estimates, and reporting methods combine in a statewide inventory.

The Iowa Department of Natural Resources (DNR) estimated gross emissions of 131.02 million metric tons of carbon dioxide equivalent (MMtCO2e) for 2017, a 3.46% increase from 2016. The total was still 5.84% below the 2008 level. Three changes drove much of the year-over-year increase: higher emissions from industrial processes, increased power plant emissions, and a rise in waste-sector emissions.

What the Iowa greenhouse gas emissions inventory measures

The inventory covers six greenhouse gases: carbon dioxide (CO2), methane (CH4), nitrous oxide (N2O), perfluorocarbons (PFCs), hydrofluorocarbons (HFCs), and sulfur hexafluoride (SF6). To compare gases with different warming effects, emissions are reported in CO2-equivalent units. The DNR applied global warming potentials from the Intergovernmental Panel on Climate Change’s Fourth Assessment Report.

Emissions estimates draw on statewide activity data across agriculture, fossil fuel combustion, industrial processes, natural gas transmission and distribution, transportation, waste, and land use, land-use change, and forestry (LULUCF). The DNR used the U.S. Environmental Protection Agency’s State Inventory Tool (SIT), alongside emissions reported by power plants, industrial facilities, and landfills under the federal greenhouse gas reporting program.

This combination matters when interpreting the results. Some figures rely on facility-reported data, while others are calculated using activity information and emission factors. The DNR’s technical support documentation describes sector methods and uncertainty; the inventory figures are therefore best read with attention to how each category was estimated.

Industrial processes and power generation drove key increases

Industrial process emissions rose from 5.51 MMtCO2e in 2016 to 7.25 MMtCO2e in 2017, an increase of 31.73%. The main contributor was ammonia and urea production. Reported CO2 emissions from that category increased 181.09%, reflecting significantly higher production at two facilities. Industrial process emissions include greenhouse gases released during manufacturing processes, rather than emissions from burning fuel to provide heat or power.

That distinction is useful for industrial energy and emissions accounting. Fuel combustion belongs in the fossil fuel combustion sector; emissions associated with processes such as ammonia, cement, lime, and iron and steel production are categorized separately. A facility’s emissions profile may therefore span more than one inventory category.

Power plant emissions increased 5.07%, from 25.33 to 26.62 MMtCO2e. The DNR attributed the increase primarily to a 52.46% rise in electricity generated from natural gas. Power plant CO2 data were based on facility reports to the federal program, with emissions measured by continuous emission monitoring systems (CEMS). The state report also notes that generation from coal, wind, and nuclear increased; wind and nuclear generation do not contribute greenhouse gas emissions in this inventory.

Sector mix puts industrial activity in context

Agriculture was Iowa’s largest emissions sector in 2017 at 39.61 MMtCO2e, or about 30% of the statewide total. Residential, commercial, and industrial fuel use accounted for about 23%, while power plants contributed about 20%. Together, fossil fuel combustion categories—power plants and residential, commercial, and industrial fuel use—totaled 56.43 MMtCO2e, or 43.07% of Iowa’s emissions.

The inventory shows that these sectors can move for different reasons. Residential fuel-use emissions increased 8.14%, while industrial fuel-use emissions were unchanged. Transportation emissions rose 1.10%, alongside a 1.47% increase in vehicle miles traveled. Agriculture emissions changed only 0.32% overall: higher manure management emissions, associated with increased swine and poultry production, were partly offset by lower enteric fermentation and agricultural soil emissions.

Waste emissions increased 28.62%, reaching 2.78 MMtCO2e. Most of the increase came from solid waste landfills, where estimated emissions rose 34.61%. The report connects landfill estimates to factors including the amount and age of stored waste, decomposition, methane recovery and flaring, climate, and oxidation rates. The change illustrates why year-to-year movement in an inventory does not always reflect a simple change in current operating activity.

Use forecast figures with their stated limitations

The DNR projected gross emissions of 130.17 MMtCO2e for 2020, 127.79 MMtCO2e for 2025, and 125.55 MMtCO2e for 2030. These projections are not guarantees. The report identifies uncertainty related to factors such as the economy, weather, regulations, energy efficiency and conservation, driving practices, and renewable fuel use. It also notes differences between the data used for the 2017 inventory and data available in the projection tool, including the tool’s use of older activity information and energy forecasts.

For technical decision-makers, the practical lesson is to distinguish measured or reported emissions from modeled estimates and forecasts. When reviewing an emissions trend, consider the reporting year, data source, calculation method, and any assumptions noted for the sector. That context helps prevent a change in a statewide total from being mistaken for a direct measure of performance at an individual facility.

What the inventory means for industrial decision-makers

Iowa’s 2017 inventory demonstrates how facility reporting and statewide modeling work together to describe emissions across a diverse economy. Industrial process production and natural gas-fired generation were important drivers of the annual increase, while agriculture remained the largest sector overall. The report also makes clear that category definitions, data availability, and model assumptions influence how results should be interpreted.

For plant and operations teams, the inventory is a useful reference for understanding the broader emissions landscape—not a substitute for facility-specific accounting. Its most practical value lies in the sector detail and transparent discussion of methods: these help readers identify which activities influence reported totals and where better data or improved forecasting could strengthen future assessments.

Access Official Technical PDF

About The Author