Understanding the microdisk laser threshold means looking beyond the pump power at which a laser line appears. In a semiconductor microdisk, device size, optical losses and the fraction of spontaneous emission captured by the lasing mode all influence how the transition to stimulated emission behaves. Measurements of InGaAs/InGaAsP microdisks emitting near 1.52 μm show how these factors interact as cavity dimensions approach the small-volume limit.
How a microdisk confines light
A microdisk laser uses a thin semiconductor disk to support optical modes that travel around its perimeter. These are known as whispering-gallery modes: light circulates along the disk edge, with the cavity geometry and refractive index helping to confine it. The devices in the study used disks 0.15 μm thick, containing six InGaAs quantum wells separated by InGaAsP barriers and supported on an InP pedestal.
The analysis approximated the disk as a two-dimensional optical cavity. For the dominant transverse-electric mode, the field pattern can be described using cylindrical modes, with their frequencies determined by the disk radius and effective refractive index. Each mode has a radial and angular mode number. The angular modes with nonzero mode number occur in pairs because of the disk’s cylindrical symmetry.
Only a limited number of modes may fall within the semiconductor’s gain spectrum. As the disk becomes smaller, the spacing between modes increases, making it more likely that one mode will dominate. This mode selection is central to understanding both the optical output and the threshold behavior.
Microdisk laser threshold and cavity losses
The cavity quality factor, or Q, describes how slowly energy stored in an optical mode decays. A higher Q generally corresponds to lower cavity loss, but a microdisk’s measured Q reflects several mechanisms rather than radiation loss alone. The analysis considered radiation leakage, absorption in the cold cavity, and additional losses such as surface roughness.
Radiation loss depends strongly on the mode and disk geometry. In the model, the radiation-limited Q for the first radial modes rises approximately exponentially with angular mode number. Material dispersion also affects the estimates of both Q and mode spacing. In the measured devices, however, other losses limited the total Q to below 1,000, while pump-dependent effects made Q an important factor in the behavior below threshold.
Photoluminescence measurements provided a way to examine the cavity resonances before lasing. The researchers studied a 2.2 μm-diameter disk and a 5 μm-diameter disk at liquid-nitrogen temperatures. Their measured cold-cavity Q values were approximately 260 and 500, respectively. The observed mode spacings—87 nm for the smaller disk and 37 nm for the larger one—were in reasonable agreement with the calculated values.
What the measurements show about threshold
Both devices were excited continuously with a HeNe laser, and output was measured against the pump power absorbed in the disk. Threshold was estimated by extrapolating the linear portion of the laser-output curve. The resulting values were 25 μW for the 2.2 μm-diameter disk and 45 μW for the 5 μm-diameter disk.
Threshold was accompanied by a change in the broader photoluminescence signal. As stimulated emission became dominant, the carrier density was pinned near threshold, and the integrated photoluminescence began to level off. Comparable nonlasing structures did not show this leveling over the same pumping range, instead exhibiting an approximately linear increase. This contrast helps distinguish the onset of lasing from a simple increase in optical excitation.
The reported threshold powers are measurements for these particular structures and conditions; they should not be treated as universal design values. The study’s broader point is that reducing cavity volume can alter the relationship between spontaneous emission and the lasing mode, changing the character of the threshold region.
Spontaneous-emission coupling in small cavities
The coupling factor, β, represents the fraction of spontaneous emission that enters the lasing mode. In a conventional laser, much of the spontaneous emission may go into modes other than the lasing mode. In a sufficiently small cavity with fewer available optical modes, a larger fraction can feed the mode that will lase. As β approaches unity, the distinction between spontaneous emission below threshold and stimulated emission above it becomes less pronounced, and the threshold is expected to become less sharply defined.
For the smaller microdisk, mode counting gave an initial estimate of β near 0.41. Accounting for emission into free-space modes and a transverse-magnetic mode reduced that estimate to about 0.29. A separate estimate based on comparing the laser-line output with the total emitted light put β near 0.15 at transparency. Rate-equation fits produced values from about 0.1 to 0.23 for the smaller disk, depending on pump level. For the larger disk, the fitted values ranged from about 0.04 to 0.06.
These different estimates should be read with their limitations in mind. The rate-equation analysis omitted a detailed treatment of carrier diffusion and assumed a single lasing mode, although two nearly degenerate modes could contribute. The researchers therefore did not consider the fitted β values accurate to better than a factor of two.
Practical implications for photonic device design
For engineers evaluating compact semiconductor lasers, the results underline the need to consider cavity geometry and mode structure together with pump power. A smaller disk can reduce the number of modes in the gain bandwidth and increase spontaneous-emission coupling, but its performance also depends on optical loss, material properties and how the device is excited. A threshold value on its own does not describe these factors.
The practical takeaway is to assess microdisk laser behavior through complementary measurements: spectral mode spacing, cold-cavity Q, laser-line output and integrated photoluminescence as pump power changes. Taken together, these indicators reveal whether a device is approaching a high-β regime and how cavity losses shape its threshold. The reported microdisks demonstrate the potential of small whispering-gallery cavities for low-threshold, high-coupling microlasers, while also showing why more complete, potentially multimode analysis is needed to characterize that regime.