For space-based memory systems, a DDR termination regulator must maintain the relationship between its termination output and reference voltage even when exposed to energetic particles. The TPS7H3301-SP radiation effects evaluation examined this concern through heavy-ion testing across DDR modes, electrical conditions, loads, and temperatures. The results provide system designers with evidence about destructive-event susceptibility and the less frequent output transients that can affect downstream memory operation.
Why single-event effects matter in a DDR termination regulator
The TPS7H3301-SP is a radiation-hardened sink/source regulator for DDR termination applications. It generates VTT/VO and VTTREF signals, which must track appropriately for reliable memory read and write operations. The evaluation focused on single-event latch-up (SEL), single-event burnout (SEB), single-event transients (SETs), and single-event functional interruptions (SEFIs).
For the output signals, the key system-level measure is the difference between VTT/VO and VTTREF. The report uses the JEDEC DDR limit of ±40 mV: an excursion beyond this difference can compromise reliable memory operation. A transient within that limit is treated as an SET with no expected impact on downstream memory. An excursion beyond it is classified as a SEFI because it can interrupt memory operation. In the observed larger events, PGOOD transitioned, flagging the condition and protecting memory from access while the signals were not tracking.
Heavy-ion test coverage and conditions
The study exposed production devices to heavy ions at effective linear energy transfer (LETEFF) values of 44.5, 52.5, 70, and 75 MeV-cm²/mg. Testing covered more than 100 experiments, with varied DDR modes, input and output voltages, loads, and temperatures. SEL testing included operation at 125°C; other evaluations included room-temperature and elevated-temperature conditions. The tested configuration monitored VTT/VO, VTTREF, PGOOD, and other device signals while applying active loads.
The results primarily describe the TPS7H3301-SP. The report also states that the tested TPS7H3302-SP QMLP version correlated with the QMLV device in destructive and transient performance. The QMLP testing was performed at 75 MeV-cm²/mg, so its coverage should be understood in that context.
Destructive-event results: no observed SEL or SEB
No SEL events were observed across the tested DDR modes and load conditions. The report summarizes the device as SEL-free up to LETEFF of 75 MeV-cm²/mg at 125°C. Current monitoring during irradiation showed no sudden increases indicative of latch-up.
SEB testing likewise produced no observed burnout events. Tests were performed at LETEFF of 75 MeV-cm²/mg at room temperature, with the device both enabled and disabled and across tested DDR modes and loads. These results address destructive-event concerns under the evaluated conditions; they do not replace mission-specific radiation assessment.
SET and SEFI behavior depends on DDR mode
No SET or SEFI events were observed up to 52.5 MeV-cm²/mg. At 70 MeV-cm²/mg, behavior differed by operating mode:
- DDR1 and DDR4: No SET or SEFI events were observed through the reported testing at 70 MeV-cm²/mg.
- DDR2 and DDR3: A small number of events occurred. Most were minor transients, and the reported SETs remained below ±5 mV—well within the ±40 mV tracking criterion.
- Rare larger transients: Some events exceeded the JEDEC tracking limit and were classified as SEFIs. Each observed event generated a valid PGOOD transition.
For these SEFIs, the PGOOD response temporarily halted memory access for approximately 20–40 microseconds while the transient recovered. The report says no event was observed in which the tracking difference exceeded the limit without a corresponding PGOOD transition. That distinction matters to system design: a flagged interruption can reduce availability briefly, while continued memory access during invalid tracking could risk data errors.
What the findings mean for system-level evaluation
The findings indicate that the principal observed concern is not latch-up or burnout, but the possibility of a transient that briefly interrupts memory operation in DDR2 or DDR3 mode at the highest tested LET level where events occurred. Engineers assessing the regulator for a space application should therefore consider the selected DDR mode and the system’s response to PGOOD, alongside the device’s destructive-event results.
PGOOD is part of the protection story, but system integration still determines how a flagged condition is handled. Designers should account for the temporary interruption of memory access and verify that system-level sequencing and monitoring respond appropriately. The report’s results apply to its tested conditions; mission radiation environment, shielding, operating configuration, and component-level requirements remain part of a complete design assessment.
Conclusion
Heavy-ion testing found no observed SEL or SEB in the evaluated TPS7H3301-SP configurations, with the report summarizing SEL immunity through 75 MeV-cm²/mg at 125°C. SET and SEFI results were also mode-dependent: DDR1 and DDR4 showed no observed events through 70 MeV-cm²/mg, while rare DDR2 and DDR3 transients included larger excursions that triggered PGOOD. For technical decision-makers, the practical takeaway is to evaluate the regulator’s DDR-mode-specific transient behavior and incorporate PGOOD handling into the memory subsystem’s fault-response strategy.