Vapor intrusion is a central design and long-term management issue when residential development is planned above groundwater contaminated with volatile organic compounds (VOCs). At the Middlefield-Ellis-Whisman (MEW) Superfund Study Area in Mountain View, California, trichloroethylene (TCE) is the most prevalent contaminant in a regional groundwater plume. The site illustrates why safe redevelopment depends not only on construction controls, but also on monitoring, maintenance, cleanup decisions, and reliable communication with building occupants.
Why vapor intrusion matters in redevelopment
Groundwater contamination does not necessarily create a drinking-water exposure pathway at a particular site. At MEW, groundwater is not used for drinking. However, TCE and other chlorinated VOCs can volatilize from contaminated groundwater or soil into soil gas. That gas may migrate upward and enter buildings through cracks in foundations, utility conduits, elevators, stairwells, and other openings in the building envelope.
Indoor concentrations depend on more than contaminant levels below a building. Soil conditions and preferential pathways can affect how vapors move, while building pressure, wind, and ventilation influence whether soil gas is drawn indoors. Utility corridors and porous subsurface materials may provide pathways for lateral migration. As a result, evaluating a proposed building requires site-specific evidence rather than assuming that distance from a known source, or a particular foundation type, eliminates the possibility of intrusion.
Vapor mitigation systems are engineering controls intended to interrupt this pathway. They reduce the pressure beneath or around a foundation or vent soil gas outdoors before it reaches occupied space. These controls can prevent exposure even when groundwater cleanup is incomplete, but they require appropriate design, verification, and ongoing care.
Vapor intrusion mitigation for new construction
EPA’s 2010 vapor-intrusion Record of Decision (ROD) Amendment for MEW requires new buildings within the Vapor Intrusion Study Area to incorporate a vapor barrier and a passive sub-slab ventilation system that can be converted to active operation, unless a developer demonstrates that vapor intrusion is not possible at the site. Depending on the location and available evidence, an active system may be appropriate from the outset.
Passive venting and active depressurization
A passive system relies on natural pressure differences and airflow to move soil gas from beneath a building toward rooftop vents. An active sub-slab depressurization system (SSDS) uses a fan to draw soil gas from below the slab and discharge it outdoors. By lowering pressure under the foundation, an active SSDS helps prevent vapors from moving into occupied areas. Its mechanical components require maintenance, and system performance must be checked.
Passive systems may be less predictable and less efficient than active systems, and may require more monitoring. Their performance can vary with environmental and building conditions. A system designed to be activated later should therefore have clear criteria for conversion, along with a process for responding when monitoring identifies unacceptable indoor-air conditions. The MEW recommendations call for EPA to define when passive systems are adequate and when active mitigation should be mandatory, particularly in areas with higher TCE concentrations.
Mitigation design also needs to address emissions and site infrastructure. Soil gas exhausted by a system may require treatment under applicable Bay Area Air Quality Management District requirements, depending on estimated VOC emissions. New utility installations should be designed to limit lateral movement of contaminated groundwater or vapor through utility backfill and conduits. Measures identified for Moffett Field development include low-permeability backfill or cutoff features and watertight utility pipes and joints.
Groundwater cleanup and building controls must work together
Engineering controls address the exposure pathway at a building; they do not remove the underlying source. The original MEW remedy relied principally on groundwater extraction and treatment. EPA reviews Superfund remedies periodically, and the site review described in the 2020 memorandum found that TCE concentrations in groundwater had leveled off above cleanup targets. It also indicated that reaching those targets in shallow groundwater could take many decades.
That gap matters because shallow groundwater and soil gas can remain sources of vapor intrusion. A proposed groundwater ROD Amendment was intended to evaluate approaches to accelerate reduction of contamination in the shallow zone. The practical implication is that redevelopment decisions should account for both current building protection and the longer-term progress of source cleanup. Where soil-gas or groundwater conditions are sufficiently high, mitigation alone may not be considered adequate for development to proceed without additional response actions.
For example, the redevelopment of 277 Fairchild Drive required additional work after investigation identified high TCE levels in soil gas and groundwater. Soil-vapor extraction and treatment and enhanced anaerobic bioremediation were used to reduce contamination before construction proceeded. This illustrates the distinction between installing a building control and addressing subsurface conditions that may present an unacceptable risk even with that control in place.
Long-term management is part of the remedy
A mitigation system is not a one-time construction feature. Its protective function can depend on continued operation, intact slabs and vapor barriers, working fans where installed, and timely response to changes in the building or subsurface. Building-specific Operations, Maintenance and Monitoring (OM&M) plans can set out responsibilities and procedures. A broader regional framework can help make those plans consistent across properties.
Long-term management may include:
- Inspecting foundations and other potential pathways from the subsurface to indoor air.
- Operating, maintaining, and monitoring mitigation equipment, including checking system performance.
- Training building maintenance personnel and documenting inspections and corrective actions.
- Monitoring indoor air, subsurface conditions, or system emissions as appropriate to the site and remedy.
- Updating procedures when building configuration, ownership, occupancy, or subsurface conditions change.
- Reporting results and periodically evaluating whether the controls remain protective.
Institutional controls complement these engineering measures. They can preserve access for sampling and maintenance, require notice of relevant changes, and ensure that future owners understand obligations associated with the property. The MEW memorandum noted that building-specific plans and a comprehensive institutional-controls implementation framework were important needs, and that monitoring schedules were not fully defined.
Occupant notification and development oversight
Protecting occupants also depends on communicating what contamination was found, what measures are in place, and whom to contact with questions or concerns. Real estate disclosures may inform purchasers, but renters, students, employees, and other non-owner occupants also need clear information. The recommendations for MEW include continued public outreach, consideration of placards on non-single-family buildings above the plume, and guidance for notifying prospective occupants beyond normal property transactions.
Responsibilities are shared. EPA is the principal regulator for the MEW Superfund area and Moffett Field, while the City of Mountain View administers zoning and building permits south of Highway 101. NASA oversees development on its property in consultation with regulators. Developers must demonstrate compliance with applicable requirements, while responsible parties and building owners have roles in funding, operating, and maintaining controls. Coordination is especially important where contamination or potential migration extends beyond established study-area boundaries.
Screening should not necessarily stop at a mapped boundary. The memorandum recommends soil-vapor evaluation for certain properties outside the existing Vapor Intrusion Study Area when they are adjacent to or downgradient from known plumes, with a minimum evaluation distance of 200 feet proposed. It also calls for developers to address potential VOC migration along utility corridors. These are recommendations specific to the MEW context, not universal design rules; appropriate evaluation depends on site conditions and regulatory direction.
Practical implications for project teams
For engineers, developers, building owners, and public agencies, the MEW experience underscores several priorities: establish site conditions early; coordinate with regulators and local permitting authorities; select mitigation based on evidence rather than convenience; define activation and maintenance triggers; and plan for monitoring and occupant communication throughout the building’s useful life.
Residential redevelopment over a contaminated plume can be managed only when building-level protections and site-wide cleanup are treated as connected responsibilities. Durable vapor intrusion management requires technically sound systems, enforceable institutional controls, long-term funding and oversight, and transparent notice to everyone who lives or works in affected buildings.