A 240 W evaluation-board design shows how power factor correction, current-mode LLC control and synchronous rectification can work together in a 12 V AC-DC supply. Learn how its control, protection and light-load features shape the design.
Articles Tagged: power factor correction
Low-Frequency Harmonics in Electronic Lighting Systems
Electronic lighting can draw distorted current and contribute to low-frequency harmonics. Measurements show that the combined behavior of multiple lamps may differ from single-lamp tests, making system-level assessment important.
Harmonic Reduction With STATCOM for Nonlinear Loads
Nonlinear loads can distort current waveforms and increase reactive power demand. Explore how a shunt STATCOM acts as an active power filter, the role of its control system, and what simulation results can—and cannot—tell engineers about harmonic performance.
Soft-Switching PFC Converter: Design and Operation
A soft-switching PFC converter can reduce switching losses while maintaining power-factor correction. Learn how coordinated ZVT, ZCT, ZVS and ZCS transitions work, and what a 500 W prototype demonstrates.
Vienna Rectifier Design and Emerging PFC Topologies
The Vienna rectifier is a three-phase power-factor-correction topology designed to shape mains current while converting AC to a controlled DC output. Learn how its operation, benefits and limitations compare with newer rectifier approaches.
SiC Totem Pole PFC for Efficient Power Supplies
A SiC-based Totem Pole PFC can reduce losses in the AC-to-DC stage of an industrial power supply by eliminating the conventional input diode bridge. See how the topology operates and what a 3.6 kW demonstrator showed in testing.
Soft-Switched Multi-Input Converters for Renewable Energy
Soft-switched multi-input converters offer an alternative to separate power converters for each renewable source. Their design can integrate single-switch input modules, AC power factor correction, and battery charging and discharge interfaces for PV-based systems.
LED Driver Reliability: Results of Accelerated Stress Testing
Accelerated stress testing examined single- and multichannel drivers used in solid-state lighting. After 2,500 hours at 75°C and 75% relative humidity, most tested units showed minimal electrical and photometric change, while two failures highlighted the importance of component-level reliability.